Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
Bring the cutter deck to the top position.
Clean the cutting chamber with a scrubbing brush,
hand brush or a cloth.
Cutters with cleaning nozzle (optional)
Cleaning
Switch the parking brake on.
Use a commercially available quick-release cou-
pling to attach a water hose.
Start the engine.
Lower the cutter deck and switch it on.
Allow the engine and cutter deck to run for a few
minutes.
Switch the engine and cutter deck off.
Note
If available, repeat the steps for the second
cleaning nozzle.
Drying
Bring the cutter deck to the top position.
Start the engine and switch the cutter deck on.
To dry the cutter deck, allow the engine and cutter
deck to run for a few minutes.
Switch the engine and cutter deck off.
Starting the device
Observe the servicing instructions in the engine
manual.
At the end of the season, have the mower in-
spected and serviced by a service centre.
Note
After changing the oil, take the waste oil
to a waste oil collecting point or to a waste
disposal company.
Note
Hand over used batteries to your dealer or to
a waste management company. Remove the
battery before scrapping the mower.
22
DANGER !
Risk of explosion / short-circuit
Never bypass a defective or frozen
battery with jump leads.
Ensure that the units and the jump lead
clips do not touch each other and that
the ignitions are switched off.
Attach the red jump lead to the positive pole (+) of
the discharged battery and to the positive pole (+)
of the donor battery.
terminal (–) of the donor battery.
Connect the other clip to the frame of the engine
block of the device as far away from the battery as
possible.
Note
If the donor battery is installed in a vehicle,
this vehicle must not be started during the
jump starting process.
Start the device.
Switch the parking brake on.
Disconnect the jump leads in reverse sequence.
Tyre pressure
WARNING !
Increased tyre pressure
Risk of accident and damage to the
device
Never exceed the permitted tyre
pressure (see tyre wall).
Check the tyre pressure and correct it where
necessary.
Note
Excessive tyre pressure reduces the service
life of the tyres. Check the tyre pressure
prior to every instance of use.
After 5 operating hours
refer to the engine manual).
Use the quick oil drain (optional) to drain the
oil
.
Note
When draining the oil, use a suitable collec-
tion container.
Maintenance
769-11757
Capítulos
Tabla de contenido
