Maintenance; Cleaning The Device - Cub Cadet Commercial 53AWEFJA603 Instrucciones De Funcionamiento Originales

Maintenance

Type 1
Oil change display
–
Change the engine oil immediately (see engine
operating manual).
This indicator appears every 50 operating hours for
a period of 2 hours.
Type 2
Maintenance indicator
– – –
Change the engine oil immediately (see engine
operating manual).
This indicator appears every 50 operating hours for
a period of 7 minutes.
– –
The engine oil level is too low.
Switch the engine off immediately and check
the engine oil level (see the engine operating
manual). Top up the oil if required.
– –
If you turn the ignition key to the
operating hours.
Charge the battery as quickly as possible.
It may be necessary to have the charging system
checked by a service centre for possible damage.
– – –
engine operating manual).
This indicator appears every 25 operating hours for
a period of 7 minutes.
769-11757
Changing the oil
Changing the oil
Oil level

Cleaning the device

Do not use high-pressure cleaners for cleaning
the device.
Switch the parking brake on.
Battery voltage
Clean the device with a scrubbing brush, hand
brush or a cloth.
position, the
Cleaning the cutter deck
-
nance
Fuel may run into the combustion chamber.
Damage to engine
The mower must not be tilted to an angle greater
than 30°.
Maintenance
WARNING !
Risk of injury or property damage
Only perform maintenance and cleaning
work on the device with the engine at a
standstill.
Remove the ignition key and the spark-
plug connectors.
Wait until all moving parts have come
to a complete stop and the engine has
cooled down.
Never reach into the rotating cutter
blades.
Only have repair and maintenance
work and the replacement of safety
specialist or a specialist service centre.
Only have the cutter blades replaced
or re-sharpened by a specialist service
centre.
Clean the device and all add-on and
accessory parts after every instance of
use.
Attention !
DANGER !
Sharp, moving cutting tools
Risk of injury
Wear protective gloves.
Caution when cleaning the cutters.
Note that the movement of one cutting
tool may lead to the rotation of other
cutting tools.
Attention !
EN
21