Operating Controls; Start-Up - Cub Cadet Commercial 53AWEFJA603 Instrucciones De Funcionamiento Originales

EN

Operating controls

Overview
1 Forward pedal
2 Reverse pedal
3 Clamping lever for steering column
4 Cutting height adjustment lever
5 Throttle / choke *
6 Choke *
7 Display cluster *
8 PTO switch
9 Light switch *
10 Ignition lock
11 12 Volt accessory socket *
12 Switch for optional grass catcher *
13 Fuel tap
14 Fuel tank
15 Tank content display *
16 Gear release lever
17 Trailer coupling *
18 Can holder
19 Seat belt
20 Seat adjustment lever
21 Adjusting knob for seat height adjustment *
22 Steering wheel
23 Switch for parking brake / speed control
24 Brake pedal
(* depending on model)
Note
For reasons of clarity, the rollbar is not
shown.

Start-up

Check:
all protective features
the engine-oil level (see the engine handbook)
the fuel level
tyre pressure
the side coverings, accessory equipment, the
Fill up with fuel and check the oil level
Note
the factory – please check the oil, if required
Use unleaded petrol.
Fill fuel tank up to max. 2 cm below the lower
edge of the inlet nozzle.
Seal the fuel tank tightly.
Check the oil level. The oil level must be between
the "Full/Max." and "Add/Min." mark (see also
engine manual).
16
Check tyre pressure
Check the tyre pressure on all wheels and correct
it where necessary (for max. tyre pressure, see
tyre wall).
design and model)
Note
Depending on the design, the device may
have an adjustable seat with a built-in pres-
ence sensor and a retractable seat strap.
Sit on the driver's seat.
Press the adjustment lever to the left and keep it
held .
Bring the seat to the desired position
the adjusting lever .
Note
When releasing the adjustment lever, make
sure the seat latches in correctly.
Move the armrests upwards
Turn the adjusting segment into the required posi-
tion :
- 0 = Lowest position
- 3 = Highest position
Move the armrests downwards.
The adjustment mechanism for the weight-depend-
ent seat suspension allows for adjustment to the
driver's weight of between 56–125 kg.
Increasing the seat hardness / carrying
capacity
Turn the rotary knob in a clockwise direction until
the required seat hardness has been reached
Reducing the seat hardness / carrying
capacity
Turn the rotary knob in an anti-clockwise direc-
tion until the required seat hardness has been
reached .
Fitting the steering column
Upper part [B] of the steering column
Release the clamping lever in an anti-clockwise
direction .
Tip the steering column forwards into the required
position .
Tighten the clamping lever in a clockwise direc-
tion to lock the steering column in this position.
Operating controls
(Depending on the
and leave
.
.
769-11757