Safety Devices; Assembly - Cub Cadet Commercial 53AWEFJA603 Instrucciones De Funcionamiento Originales

EN

Safety devices

Rollbar [B] and seat belt
WARNING !
Risk of falling
Never use the device without the rollbar.
Do not operate the device with the rollbar
folded down.
Always wear a seat belt when the rollbar
is folded up.
The rollbar must always be locked in
a folded up, vertical position with the
bolts and safety splints designed for this
purpose, and secured.
Do not fasten the seat belt when the
rollbar is folded down.
In the case of damage or an accident,
have the rollbar and seat belt checked
in a specialist garage, and replace if
necessary. Do not undertake any repairs
on your own!
The device is equipped with a rollbar and seat belt.
Together, they represent optimal protection for the
driver.
Discharge flap [A]
CAUTION !
Contact with the cutting blade and items
Risk of injury
Only operate the device with a discharge
Safety interlock system
The safety interlock system will only allow the
engine to start when
- the driver is sitting on the seat,
- the brake pedal has been depressed or the parking
brake is in the park position,
- the cutter deck has been switched off; i.e.: PTO
switch set to "O/Aus/Off" (PTO = Power-Take-Off).
The safety interlock system automatically switches
the engine off as soon as the operator leaves the
seat with the cutter deck activated (PTO), irrespec-
tive of whether the parking brake was actuated
beforehand.
The safety interlock system automatically switches
the engine off as soon as the operator leaves the
seat without actuating the parking brake beforehand.
14
Directional references
Directional references on the device (e.g. left, right,
etc.) always refer to when facing forwards.

Assembly

Note
To be able to move the device manually, the
gear release lever must be in the appropri-
ate position. Refer to the section "Operation
– Pushing the mower",
Setting up the rollbar
The rollbar is folded down for transport.
Remove the splint from the securing pins
Remove the securing pins
Fold out the rollbar fully
Insert the securing pins through the holes
Secure the bolts with the splints
Fitting the steering column
Note
Only for devices where the bottom steering
column has been folded down for transport.
Bottom part [A] of the steering column
Press the bottom part of the steering column for-
wards out of the transport position
Fix it using the two screws and washers sup-
plied .
Upper part [B] of the steering column
Release the clamping lever in an anti-clockwise
direction .
Tip the steering column forwards into the required
position .
Tighten the clamping lever in a clockwise direc-
tion to lock the steering column in this position.
Installing the steering wheel
Remove cover cap [1] ([A] or [B] depending on
model) from the steering wheel.
Remove screw [2] and the washer [3].
Bring the wheels into a straight position.
Place the steering wheel on the steering shaft.
Put on washer [3] with curved side face up.
Fix the steering wheel using the screw [2].
Insert the cover cap [1] ([A] or [B] depending on
model).
Safety devices
.
.
.
.
.
.
769-11757