Cub Cadet SurePath Pro Z Serie Manual Del Operador página 15

3. Rotate both locking pins into the
LOCKED position. Move the upper
ROPS slightly until the locking
pins are fully engaged in the
LOCKED position.
26. Accessory Switch Receptacles
The two receptacles for optional
accessories are on the RH console. See
the Attachments & Accessories section
for information.
27. 12V Outlet (If equipped)
The 12V outlet is located to the right of
the operator's seat on the lower panel of
the RH console and is used for the
convenience of plugging in accessories
that require a power source with a
maximum load of 5A at 12V.
28. Fuel Gauge(s)
There is a fuel
gauge on top
of each of the
two fuel tanks
or a single
gauge to the right of the operator's seat
on the RH console. The gauges measure
the fuel level in each tank.
29. Fuel Valves
The fuel valves are located
near the rear of each fuel
tank. The valves control
the fuel flow from the
right and left tank and
also can shut off fuel flow to the engine.
Rotate the valve counter-clockwise to
open the flow from the tank(s). Rotate
the valve clockwise to stop the flow
from the tank(s). The fuel tanks can be
operated together, independently or
shut the fuel flow off completely.
NOTE: If both tanks are on, and one
is empty, the engine will not start. Be
certain to make sure both tanks have
fuel or that the empty tank's fuel valve
is closed.
30. Global Positioning Module (GPM)
(SurePath Auto Steer System)
The Global Positioning Module (GPM),
mounted to the front of the steering
wheel column, is the main component of
the SurePath Auto Steer system.
The GPM includes:
• Light Module (Indicator/Warning
Lights) - the Indicator/Warning
Lights are mounted on the back
(facing the operator) of the GPM
and visually communicate the
status of the SurePath Auto Steer
system to the operator. The two
lights will always match in color and
operation (flashing or solid).
Indicator/ Indicator/
Warning Warning
Lights Lights
Blue
Blue
Green
Blue
Yellow
Red
L
` ç å í ~ á å ë = c ` ` = f a W O ^ ^ V _ N M = = ` ç å í ~ á å ë = c ` ` = f
• 4G Modem Antenna - integrated
q Ü á ë = Ç É î ê í = N R = ç Ñ = í á Å É = Å ç ã é ä á É ë = ï
l é É ê ~ í í á ç å = á ë = ë ì = í Ñ ç ä ä ç ï ç = í
antenna for the 4G Modem. E N F = q Ü á ë = Ç É î ê ã Ñ ì á Å É = ã ~ ó = å ç í ê Ñ
= E O F = q Ü á ë = Ç É î á Å É = ã ì ê Ñ É ê É å Å É = ê É Å É á î
á å Å ä ì ê Ñ É ê É å Å É = í Ç á å Ö = á å í
• On-Board Computer - the GPM
=
houses the main microprocessors,
software and logic to provide
guidance to the equipment's
drive systems.
See Service in the Product Care section
for information on servicing the GPM.
31. Operator Control Panel (SurePath
Auto Steer System)
Left
Turn
Button
Set Line/
Engage Auto
Button
GPS — Green indicators will flash on the
Light Module and Operator Control Panel
GPS indicator while the GPM is actively
searching for a signal and will turn solid
green when signal is acquired.
LINE — Initially the LINE indicator will be
off. The LINE indicator will flash green
when first point (A) has been set and will
turn solid green once second point (B)
has been set.
IMPORTANT! Operator should drive a
minimum of 10 yards (30 feet) between
setting point A and point B.
AUTO — The AUTO indicator will be
solid green when mower is in auto mode
and will flash slowly when mower is in
manual mode with auto mode available
(points A and B have been set and GPS
signal is good). The AUTO indicator is
off when the mower is not ready for
auto mode.
NOTE: Auto indicator will only flash after
overriding auto mode by turning the
steering wheel slightly to the right or left
or if the system loses GPS signal. Points A
and B remain set.
LEFT TURN BUTTON — Mower will
perform an automated zero turn to the
left while in SurePath Auto Steer Mode.
RIGHT TURN BUTTON — Mower will
perform an automated zero turn to the
right while in SurePath Auto Steer Mode.
SET LINE/ENGAGE AUTO BUTTON — Sets
a W o f s O T i b V N M k ^
beginning (A) and ending (B) points for
` = o ì K ä É ë Ü É = c ` á í Ü = é ~
Ü É = á å Ö = í W Ä à É Å ï ç = Å ç å Ç á í á ç å ë
É ê É å Å É ä = á å í I Ç = ~ å É = Å ~ ì automatic mowing. This button is also ë É = Ü ~
I ë í = ~ Å Å É é í É Ç = ~ å ó = á å í
Ü ~ í É = ã ~ ó = Å ~ ì ë É = ì å Ç É ë á ê É Ç = ç é É ê ~ í
used to resume auto mode (press once
after system is disengaged).
NOTE: SET LINE/ENGAGE AUTO button
also serves as the reset button to clear
the set line. See Clearing the Mowing
Line (SurePath Auto Steer Mode) later in
this section for more information.
Before Operating Your Mower
1. Before you operate the mower,
study this manual carefully to
familiarize yourself with the
operation of all the instruments and
controls. It has been prepared to
help you operate and maintain your
machine efficiently.
Right
Turn
2. Fill the fuel tank with only clean,
Button
fresh, unleaded gasoline with a
pump sticker octane rating of 87 or
higher. When the fuel reaches 1/2"
below the bottom of the fill neck,
stop. DO NOT OVERFILL. Space
must be left for expansion.
3. Never use gasoline containing more
than 10% ethanol or methanol.
4. Check the engine oil level
as instructed in the Engine
Operator's Manual.
S 3 — c
ection
É
á ç å K
& o 15
ontrolS peration