Operation - Bosch T1B Instrucciones De Funcionamiento Y Seguridad

2610001768_T1B 8/17/17 8:57 AM Page 11
USING THE EXTENSION RAILS
See Figure 12.
Use the extension rails (1) when working with larger
workpieces.
To extend the rails:
1. Loosen the extension adjustment knob (2).
2. Extend the rail (1) to the desired position.
3. Tighten the extension adjustment knob.
WORK SUPPORT HEIGHT ADJUSTMENT
See Figure 13.
1.Loosen the work support locking knob (3) located at
the end of the expansion rail, as shown in figure 13,
and raise the work height support (4) so it is level
with the table top of the attached miter saw.
2.Retighten knob and repeat on opposite side.
are adjusted so that the workpiece sits flat on the
miter saw table. Workpieces that do not sit flat could
cause the blade to bind during cutting.
USING THE WORK STOPS
See Figure 14.
Raise the work stops (5) whenever you need to make
repetitive cuts of the same size. To avoid a greater
risk of binding or pinching, do not use both work stops
at the same time.
To raise the work stops:
1. Loosen the work stop adjustment knob (6).
2. Raise the work stop (5) to the desired position.
3. Tighten the work stop adjustment knob.

Operation

To reduce the risk of injury,
ensure that the work supports
FIG. 12
1
FIG. 13
3
FIG. 14
6
11
2
4
5