Worx NITRO SWITCHDRIVER WX177L Manual Del Usuario página 12

Installing the Battery Pack and Starting
the Machine
As you install the battery pack, the LED
light will turn on, the light turns on, a
boot screen will appear. After a while,
the screen will show number"1".
PREOPERATION SETUP
Installing a 1/4" hex SCREWDRIVING bit
The machine is ideally inserted with one
drilling bit and one screw driving bit.
After you start the machine for the first
time, the default mode is screw driving
at torque level 1.
Insert a 1/4" hex SCREWDRIVING bit into
the chuck locking sleeve
Installing the DRILL bit
Place forward/reverse rotation control in
the middle position, push the dual chuck
release button to the bottom and rotate
the dual chuck . The
the light turns on.
Insert a 1/4" hex DRILL bit into the other
chuck locking sleeve.
Rotating the dual chuck enables the
working mode to the corresponding bit
12
Removing the Bit
Pull the 1/4" Hex drive chuck forward to
release the bit
OPERATION
Forward/Reverse Rotation Control
1.) To lock the trigger, push the control
switch to the center position. The trigger
will not work when the control switch is in
the locked position (E1)
2.) For forward (clockwise) rotation, push
the control switch in the direction shown.
Check the direction of rotation before
use. (E2)
3.) For reverse (counterclockwise)
rotation, push the control switch in the
direction shown. Check the direction of
rotation before use. (E3)
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
20V Cordless Brushless SWITCHDRIVER 2.0
See Fig.
A3,A4
See Fig. B1
See Fig.
light goes off and B2,B3
See Fig. C
See Fig. D
See Fig.
E1, E2, E3
Two-speed Gear Control
Push the speed gear control switch back
to "1" for low speed.
Push the speed gear control switch
forward to "2" for high speed.
WARNING: To prevent gear
damage, always allow the chuck
to come to a complete stop before
changing gears.
Drilling/driving Mode and Torque Setting
Press the drill digital keypad to toggle
between screwdriving and drilling
modes.
Press the screwdriving digital keypad to
adjust torque level.
Short press for single level change, long
press for consecutive level change.
ON/OFF SWITCH
To power the tool, pull the trigger.
NOTE: An LED is turned on when the
trigger is pulled.
2. To vary the driving speed, increase or
decrease pressure on the trigger. The
further the trigger is pulled, the greater the speed, up to the maximum speed set
by the speed control switch.
3. To stop the tool, release the trigger and
the electric brake stops the tool instantly.
WARNING: Do not operate for
long periods at low speed, or
excess internal heat will be produced.
See Fig. F
See Fig.
G1,G2
See Fig. H
EN