B
1
7/16" (11 mm)
2
7/16 de po. (11 mm)
11 mm (7/16 de pulg.)
3
INSTALLATION
B
WIRE THE DOOR CONTROL
Install the door control within sight of the door at a minimum
height of 5 feet (1.5 m) where small children cannot reach, and
away from the moving parts of the door. For gang box installations
it is not necessary to drill holes or install the drywall anchors. Use
the existing holes in the gang box.
NOTE: Pre-wiring means that your garage already has wires
installed for the door control.
1 Unplug the garage door opener to prevent the garage door
opener from activating during wiring.
2 Strip 7/16 inch (11 mm) of insulation from one end of the wire
and separate the wires.
3 Connect one wire to each of the two screws on the back of the
door control. The wires can be connected to either screw.
PRE-WIRED INSTALLATIONS: Choose any two wires to
connect, but make note of which wires are used.
C
DRYWALL
6ABx1-1/4"
6AB x 1-1/4 po.
6ABx1-1/4 de pulg.
3
1
2
C
MOUNT THE DOOR CONTROL
1 Mark the location of the bottom mounting hole and drill a 5/32
inch (4 mm) hole.
2 Install the bottom screw, allowing 1/8 inch (3 mm) to protrude
from the wall.
3 Position the bottom hole of the door control over the screw and
slide down into place.
4 Lift the push bar up and mark the top hole.
5 Remove the door control from the wall and drill a 5/32 inch
(4 mm) hole for the top screw.
6 Position the bottom hole of the door control over the screw and
slide down into place. Attach the top screw.
7 Close the push bar.
HARDWARE
GANG BOX
6-32x1"
Drywall Anchors
6-32 x 1 po
Chevilles pour mur sec
6-32x1 de pulg.
Tarugos para panel de pared
7
4
6
5
2
D
1
2
D
WIRE TO GARAGE DOOR OPENER
1 Strip 7/16 inch (11 mm) of insulation from the end of the wire
near the garage door opener.
2 Connect the wire to the red and white terminals on the garage
door opener. The wires can be connected to either terminal. To
insert or release wire, push in tab with screwdriver tip.
3 Reconnect power to the garage door opener. If the door control
has been installed and wired correctly, a message will display
on the screen. To synchronize the garage door opener and the
door control, press the push bar up to 3 times, until the garage
door opener activates. The time and temperature will display on
the door control when the door control and the garage door
opener are synchronized.
PRE-WIRED INSTALLATIONS: Connect the same wires to the
garage door opener that were previously connected to the
door control.
7/16" (11 mm)
7/16 de po. (11 mm)
11 mm (7/16 de pulg.)
WHITE
BLANC
BLANCO
RED
GREY
ROUGE
GRIS
ROJO
