ATH-Heinl ATH-W Manual De Instrucciones página 69

1.3.3. Selecting the balancing type
DYN
Dynamic – mode (standard):
This function calculates the radial and lateral
run-out of an aluminium or steel wheel rim.
The balancing weights are positioned on the
exterior and interior of the wheel.
STA
Static – mode:
This function calculates the radial run-out of a
steel wheel rim.
The balancing weights are positioned centrally
on the wheel rim.
ALU -1-
These functions calculate the radial and lateral
run-out of an aluminium wheel rim.
The balancing weights are positioned at a pre-
defined point.
ALU -2-
These functions calculate the radial and lateral
run-out of an aluminium wheel rim.
The balancing weights are positioned at a pre-
defined point.
ALUS
These functions calculate the radial and lateral
run-out of an aluminium wheel rim.
The balancing weights are positioned at a
location that has been pre-defined by the user.
We recommend selecting the ALUS mode to balance aluminium wheel rims. This mode not only
takes into account the exact cross section of your wheel rim, but also helps you to precisely position the
adhesive weight.
If using ALU 1, the following measurements must be observed when attaching adhesive weights:
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-10
- 8 -