Honda PCX150 2020 Manual Del Propietário página 278

ID number input success
After the last ID number is inputted, through,
the ignition switch ring and Honda SMART
Key Indicator will flash every 2 seconds until
the EM mode coupler is removed.
Be sure to remove the EM mode coupler and
return the blue dummy coupler. Buzzer rings 2
times when the EM mode coupler was removed
( ). The ignition switch is then
AG, CO type only
unlocked. Reinstall the parts in reverse order of
removal and turn the ignition switch to the (On)
position within 6 minutes. You can start the engine.
To lock the ignition switch, turn the ignition switch
to the SEAT FUEL, (Off), or
and press and hold the ignition switch for 2
seconds. Buzzer rings 1 time (
ignition switch also locks automatically when the
ignition switch has been in the SEAT FUEL,
(Off), or (Lock) position for about 6 minutes
after the ID number is successfully inputted.
When the ignition switch is locked, the ignition
switch ring goes off.
(Lock) position,
). The
AG, CO type only
Unlock the Ignition Switch in an Emergency
To unlock the ignition switch again, repeat the
procedure for unlocking the ignition switch.
ID number input failure
After the last ID number is inputted, the ignition
switch ring and Honda SMART Key Indicator will
flash every second until the EM mode coupler is
removed, and the ignition switch cannot be
unlocked.
Pull out the EM mode coupler and reconnect it to
the EM mode connector. Follow the procedure
again. P. 120
2
ID number input cancel
Pull out the EM mode coupler from the EM mode
connector.
Also, if you make a mistake while inputting the ID
number, remove the EM mode coupler from the
EM mode connector, connect it to the EM mode
connector again, and then re-input the ID number
from the beginning.
Store the removed EM mode coupler in the
●
tool kit at all times.
121