Adjusting The Cutting Height - Worx WG787 Manual De Instrucciones

2) Raise the safety flap and hold it up.
3) Slide the mulch plug into the discharge
opening until it is firmly in contact with the
deck.
4) Release safety flap and ensure it is properly
closed.
3. rEMoviNG MULCh PLUG (13) (See h)
Remove the mulch plug when you desire to
either collect grass or discharge grass from the
rear of the mower.
1) Shut the mower off, wait until the blade
stops and remove the safety key (5).
2) Raise the safety flap and hold it in the up
position.
3) Grasp the handle on the mulch plug (13)
then lift upward and pull it out.
4) Release safety flap and ensure it is properly
closed.
4. iNTELLiCUT CUTTiNG MoDE SELECTioN
(See i)
QUiET MoDE
16 16
Select QUIET mode (18) when mowing in
everyday conditions, removing approximately
1 inch of grass at a time.
PowEr MoDE
Set the dial to POWER mode (18) when cutting
dense or overgrown grass.
5. BaTTEry STaTUS LED'S (See J)
NoTE: The Status LED's will indicate the
battery condition when the button on the
battery is pressed.
The LED's displays the battery condition as
follows:
Press the button "POWERTEST" , the power
level light(s) button is illuminate.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
battery is in a moderately charged condition.
When only one green light (
the battery charge is very low and should be
recharged.
Before using your new mower for the first
3-in-1 Cordless Lawn Mower
All manuals and user guides at all-guides.com
) are illuminated, the
) is illuminated,
time, it is recommended that the unit be
charged overnight to ensure that the battery is
fully charged.
iMPorTaNT
when only one light is illuminated, your
battery is discharged, even though the
mower may still be capable of cutting
grass. Continuing to operate your
lawnmower with the battery in this
discharged condition may reduce the life
and performance of your battery.

6. aDJUSTiNG ThE CUTTiNG hEiGhT

(See k)
warNiNG! Stop, release switch lever
and wait until the motor stops before
adjusting height. The blades continue to rotate
after the machine is switched off, a rotating
blade can cause injury.
CaUTioN: Do not touch rotating blades.
For the first cutting of the season, a high
cutting adjustment should be selected. The
lawnmower can be set to 6 cutting heights
between 1.5" (38mm) and 3.5" (88mm).
For this purpose, move the cutting height
adjustment lever outwards then adjust to the
preferred position.
7. GraSS BaG FiLLiNG iNDiCaTor (See L)
To alert you that the grass bag is full, the
mower provides an grass bag level indicator
on the top of bag.
Empty status: flap float (a)
Fully status: flap fall down (b)
8. rEar DiSCharGE (See M)
The mower provides a rear discharge function,
so that you can mow collecting or mulching
the grass. Grass clippings will be discharged
from the rear chute of the mower and exit
below the safety flap.
9. MowiNG TiPS
NoTE: always inspect area where mower
is to be used and remove all stones,
EN