Kärcher K 2.900M Manual Del Usuario página 14

CAUTION
Disconnect the machine from the power
source before making any repair.
Symptom
Motor will not start
Unit does not reach
high pressure.
Output pressure
varies high and low.
14
English
All manuals and user guides at all-guides.com
TROUBLESHOOTING
Cause
On/Off switch is in the "OFF"
(O) position.
Power cord is not plugged in. Plug in power cord.
Electrical outlet does not
supply adequate power.
Tripped circuit breaker.
Diameter of garden hose is
too small.
Water supply is restricted.
Not enough inlet water
supply.
Water inlet filter is clogged.
Spray wand is on low
pressure position.
Not enough inlet water
supply.
Pump is sucking air.
Water inlet filter is clogged.
Discharge nozzle is
obstructed.
Calcified gun, hose or spray
wand.
Solution
Turn switch to the "ON" (I)
position
Try a different outlet.
Switch off pressure washer.
GFCI will reset once the
temperature of the unit drops.
Replace with a 5/8 inch or
larger garden hose.
Check garden hose for kinks,
leaks and blockage.
Open water source full force.
Remove filter and rinse out in
warm water.
Turn spray wand to high
pressure position.
Turn water on full force.
Check garden hose for kinks,
leaks or blockage.
Check that hoses and fittings
are air tight. Turn off machine
and purge pump by
squeezing trigger gun until a
steady flow of water emerges
through the nozzle.
Remove filter and rinse out in
warm water.
Blow out or remove debris
with a fine needle.
Run distilled vinegar through
detergent suction tube.