How To Remove And Install: Door - AEG BSE576321M Manual De Instrucciones

12.3 How to clean: Water tank
Step 1 Turn off the oven.
Step 2 Place a deep pan below the steam inlet.
Step 3 Pour water into the water drawer: 850 ml. Add citric acid: 5 teaspoons. Wait for 60 min.
Step 4 Turn on the oven and set the function: True Fan + Steam. Set the temperature to 230 °C. Turn off
the oven after 25 min and wait until it is cold.
Step 5 Turn on the oven and set the function: True Fan + Steam. Set the temperature between 130 and
230 °C. Turn off the oven after 10 minutes and wait until it is cold.
To prevent limestone residue empty the water tank after each steam cooking.
Turn off the oven.
The table below shows water hardness range (dH) with the corresponding level of calcium
deposit and the quality of water. When water hardness exceeds level 4, fill the water drawer
with bottled water.
Water hardness
Level dH
1 0 - 7
2 8 - 14
3 15 - 21
4 22 - 28

12.4 How to remove and install: Door

The oven door has two glass panels. You can remove the oven door and the internal glass
panel to clean it. Read the whole "Removing and installing door" instruction before you remove
the glass panels.
CAUTION!
Do not use the oven without the glass panels.
22 ENGLISH
When the cleaning ends:
Empty the water tank.
Refer to Daily use,
"Emptying the water
tank" chapter.
Test strip
Rinse the water tank and clean
the remaining limestone residue
with a soft cloth.
Calcium deposit Water classi‐
(mg/l) fication
0 - 50 soft
51 - 100 moderately hard
101 - 150 hard
over 151 very hard
Clean the drain pipe with
warm water and a mild
detergent.
Clean the wa‐
ter tank every
75 cycles - 2.5
months
50 cycles - 2
months
40 cycles - 1.5
months
30 cycles - 1
month