Suggestions For Use - DeLonghi DBM8150 Instrucciones Para El Uso

Operate the appliance for a few seconds at the
maximum position (3) then empty the jar.
Repeat the operation if necessary.
• Remove the blender jar, lid and measuring cup
and wash in lukewarm water by hand. Rinse
and dry thoroughly.
• To facilitate cleaning, in certain models the
blade unit can be removed as follows:
1. Remove the jar from the base and turn it
upside down.
2. Insert the hooks on the end of the measuring cup
(A) into the notches on the bottom of the uptur-
ned jar (see fig. 4).
3. Turn the measuring cup clockwise (fig. 5) as far
as it will go then pull until the blade unit and the
the gasket are released (fig. 6).
4. Wash, dry, then reassemble, taking care to
replace the gasket correctly. Position the blade
unit on the bottom of the jar, pressing down until
it fits in place, then use the measuring cup (A) to
rotate the blade unit counter-clockwise as far as
it will go.
The blender jar, the lid and the food tray must
not be washed in the dishwasher or in boiling
water.
• Take care when handling the glass jar to avoid
damage.
• Clean the motor base with a damp cloth or
sponge.
Dry thoroughly with a soft cloth.
• Wrap the power cable carefully around the bot-
tom of the motor base.

SUGGESTIONS FOR USE

1 General
• In order to get the best results, and so that the ingre-
dients do not spill out of the blender jar, add the
ingredients to the jar at little at a time.
• Do not fill the jar more than full – the movement of
the blades will increase the volume of the ingredients
in the jar. The recipes that use large quantities of
ingredients should be processed in batches.
• Pour in the liquid ingredients before the solid ones,
as long as the recipe doesn't say otherwise.
6
All manuals and user guides at all-guides.com
The liquid will facilitate the processing and will allow
for the use of a lower speed. Always add a cup of
water before processing ice.
• Blend for 5 – 30 seconds and then check the consi-
stency. Continue to process the ingredients in this
way until the desired consistency is obtained. Be
sure to not process the ingredients too much; this
could cause a loss of consistency to the entire recipe.
• Always use the blender with the lid well inserted.
• DO NOT remove the blender jar from the motor
housing while the appliance is in use.
• In order to avoid the possibility of injury to the user
or damage to the appliance, do not insert hands or
utensils into the jar while the appliance is operating.
It is possible to utilize a spatula while the appliance
is turned off.
2 Solid ingredients
• It is necessary to pay particular attention during the
processing of fine ingredients. In this case, it is
necessary to interrupt the processing from time to
time, take off the lid and scrape the ingredients
down off the sides of the jar and the blades. Then
reinsert the lid and continue processing. If the pro-
cessing becomes lengthy in this way, select a higher
speed.
• To add solid ingredients to the blender jar, remove
the measuring cup from the lid and add them a little
at a time through the hole in the lid. The vegetable
and cheese ingredients must always be cut into
cubes before being added to the jar.
3 Hot preparations
It is always necessary to remove the measuring cup
from the lid before beginning the preparation of hot
recipes.
• Slowly add the hot ingredients, maximum 2 cups at
a time, through the hole in the lid.