Machine Setup; Wet Vacuuming; Dry Vacuuming; Machine Operation - Nobles Typhoon 16B 608817 Manual Del Operador

OPERATION

MACHINE SETUP

WET VACUUMING

1. Open machine cover and remove vacuum bag
from recovery tank (Figure 9).
FIG. 9
2. Make sure automatic float shut-off screen is in
place (Figure 10).
FIG. 10
ATTENTION: To prevent vacuum motor damage,
automatic float shut-off screen must be in place.

DRY VACUUMING

1. Open machine cover and install cloth filter bag,
make sure that the bag edge is properly seated on
compartment rim (Figure 11).
For easy debris disposal and to increase the life of
cloth filter bag, use a paper vacuum bag with the
cloth bag. Place the paper bag inside of cloth bag
and tuck the top of paper bag around outside rim
of cloth bag. Never use paper bag without cloth
filter bag in place. Do not reuse paper bags –
always dispose.
8
Home Find... Go To..
FIG. 11
ATTENTION: Always make sure that a bag is in
place before dry vacuuming. Operating machine
without bag in place will damage vacuum motor.
This damage is NOT covered by warranty.
2. Close cover and fasten latches.
3. Leave automatic float shut–off screen in place
when dry vacuuming. It can provide limited
vacuum motor protection for a faulty bag.

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
WARNING: Do Not Operate Machine In Or
Near Flammable Liquids, Vapors Or Combustible
Dusts.
WARNING: Do Not Pick Up Flammable Or
Toxic Materials, Burning Or Smoking Debris.

VACUUM MOTOR THERMAL PROTECTOR

The vacuum motor is thermally protected by a
temperature sensor device. It will trip if motor has an
overload. If motor should quit, wait 20 minutes for
motor to cool and remove obstruction before
continuing.
Typhoont 16B (10–03)