Tabla de contenido
The bathr need continuated supervision to avoid contamination.
The bath should be cleaned regularly, as recommended by ORTOTECSA. The times you reuse the
paraffin determine the frequency with which the bath is to be cleaned, but is recommended in intervals
not exceeding six months.
MAINTENANCE GUIDE
1.
Inspect the environmental conditions in which the bath is located. Avoid storage in wet places.
Do not stack other devices or equipment on the top the paraffin bath.
2.
Perform integral external and internal cleaning service.
3.
Externally inspect the equipment and its main accessories.
4.
Check cord and other electrical components.
5.
Lubricate moving parts with any comercial lubricant spray.
6.
Check the accuracy of temperature control.
7.
Check the correct operation of the equipment in conjunction with the operator.
8.
The glove or sock which is formed during the treatment should not be added directly to the bath,
but collect and sterilized at 80 ° C, or with boiling water.
9.
It is also necessary to renew entirely contents of the bathevery six months and clean it properly,
since the surface with traces of skin is an excellent medium for bacterial culture.
10. In physiotherapy services is recommended to have at least one unit for hands and one for feet.
11. The unavoidable dirt residues originate by the paraffin in the around zones and in table, on the
floor etc,, should put the units in a separate area.
PARAFFIN CLEANING SYSTEM
Paraffin cleaning is performed according to their use and degree of dirty.
The temperature is increased to proceed to the emptying of the bath (Recommended 90º).
Empty the bath content in a tank for this type of residues according the laws in force in the
country. Dont pour down into the drain or down the toilet
The procedure to clean the bathroom with soap and water. It should be necessary to pay attention
in all those areas with corners and more difficult to reach. If it is necessary use a brush
Possible malfunctions
.
INCIDENCE
Bath doesn't switching-on
Bath doesn't heat.
Ortotecsa,s.l. C/Peña de Francia,8
Tlf.:+34918719132
CLEANING PRODUCT
TROUBLESHOOTING GUIDE:
Check that there is right voltage at the socket used.
Press the switch to switch-ON .
Check that the thermal cut-out has not tripped (this
can jump caused by paraffin overheating or caused
for not maintain the water level of the team at the
level indicated in the instructions).
Check that the equipment is used with the proper
water level (otherwise, it can tripped the thermal
cut-out and burn resistance).Check the conditions
of the power cord.
If still remains the problema go to our authorized
service.
Si el baño de parafina está encendido pero no
28500 Arganda del Rey (Madrid), España.
Fax: +34918719323
email:
INSTRUCCIONES DE USO Y MANTENIMIENTO
USER AND MAINTENANCE MANUAL
Last Revision 12/03/2020
RECOMMENDATION
www.ortotecsa.com
Página 26 de 37
Tabla de contenido
