Nokia N73 Manual Del Usuario página 102

Depending on the data connection you select, only certain
setting fields are available. Fill in all fields marked with
Must be defined or with a red asterisk. Other fields can be
left empty, unless you have been instructed otherwise by
your service provider.
To be able to use a data connection, the network service
provider must support this feature, and if necessary, activate
it for your SIM card.
Packet data
Follow the instructions from your service provider.
Access point name—You obtain the access point name
from your service provider.
User name—The user name may be needed to make a data
connection, and is usually provided by the service provider.
Prompt password—If you must enter the password every
time you log in to a server, or if you do not want to save
your password in the device, select Yes.
Password—A password may be needed to make a data
connection, and is usually provided by the service provider.
Authentication—Select Normal
Homepage—Depending on the access point you are setting
up, enter the Web address or the address of the multimedia
messaging center.
Select Options > Advanced settings
following settings:
or Secure.
to change the
Network type—Select the internet protocol type to use:
IPv4 or IPv6. The other settings depend on the selected
network type.
Phone IP address (for IPv4 only)—Enter the IP address of
your device.
DNS address—In Primary DNS
of the primary DNS server. In
the IP address of the secondary DNS server. Contact your
internet service provider to obtain these addresses.
Proxy serv. address—Define the address for the proxy server.
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data conn.—If you select
are in a network that supports packet data, the device
registers to the packet data network. Starting an active
packet data connection (for example, to send and receive
e-mail) is quicker. If there is no packet data coverage, the
device periodically tries to establish a packet data
connection. If you select When
packet data connection only if you start an application or
action that needs it.
Access point—The access point name is needed to use your
device as a packet data modem to your computer.
address, enter the IP address
Secondary DNS addr., enter
When available and you
needed, the device uses a
101