Automatic timer
With this function you may select a cooking time for all
hotplates. Once a hotplate is switched on, the selected time will
begin to count down. The hotplate will automatically switch off
when the cooking time has elapsed.
Instructions on activating the timer are found in the chapter
entitled "Basic settings".
Note: The cooking time of a plate may be cancelled or
changed:
Select the hotplate using the Tipp control. Press the
and change the cooking time using the Tipp control, or set
to
.
‹‹
Automatic time limitation
If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. On the hotplate display,
flash alternately.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
Cleaning lock function
Cleaning the control panel while the hob is on may change the
settings.
In order to avoid this, the hob has a cleaning lock function.
Press the
symbol. A signal sounds. The control panel is
"
locked for 35 seconds. The surface of the control panel can
now be cleaned without risk of changing the settings.
Note: The lock does not affect the main switch. The hob may
be switched off when desired.
Basic settings
The device has several basic settings. These settings may be
adapted to the user's individual needs.
Indicator
Function
Childproof lock
™‚
Deactivated.*
‹
Activated.
‚
Sound signals
™ƒ
Confirmation beep and error signal deactivated.
‹
‚
Only confirmation beep deactivated.
All signals activated.*
ƒ
*Factory settings
30
The timer
The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
No hotplate should be selected.
Press on the
1.
display shows
Select the required time using the Tipp control.
symbol
2.
3
The timer starts to count down after a few seconds.
Once the time has elapsed
A warning beep sounds. The time program function displays
and the indicator
‹‹
off the indicators and stops the beeping.
Changing or cancelling the time
Press the
3
control, or set to
"
and
‰
3
symbol, and the time program function
.
‹‹
comes on. Pressing any symbol turns
V
symbol and change the time using the Tipp
.
‹‹