HAMPTON BAY ROCKPORT 91850 Guía De Uso Y Mantenimiento página 11

Assembly - Hanging the Fan (continued)
5
Mounting the fan-motor assembly (standard mount)
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
WARNING: The locking slots of ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and firmly tightened.
□
Align the locking slots of the canopy (C) with the two screws
(II) in the mounting bracket (A). Push up to engage the slots
and turn clockwise to lock in place.
□
Firmly tighten the two mounting screws (II).
□
Install the two canopy screws (HH)(saved from Assembly Step
1 "Prepairing for mounting") into the holes in the canopy (C)
and tighten firmly.
Assembly - Attaching the Fan Blades
1
Fastening the blade brackets to
the motor
WARNING: Remove the rubber motor stops on the bottom of
the fan before installing the blades or testing the motor.
NOTE: Your fan features revolutionary advancements for quick
and easy blade installation, including an alignment post and
captive blade bracket screws.
IMPORTANT: The switch cup has an access hole (ZZ) to allow
the screwdriver to reach the screws in the blade bracket.
Position the blade bracket on the motor and tighten by
inserting the screwdriver through the access hole (ZZ).
□
Fasten the blade brackets (G) to the fan-motor assembly (D) by
inserting the alignment post into the slot on the bottom of the
motor and tightening the pre-installed blade bracket screws (QQ)
by inserting a screw driver through the access hole (ZZ).
□
Repeat this step for the remaining blade assemblies by rotating
the motor until the next blade bracket screw can be accessed
through the access hole (ZZ) in the switch cup.
II
10
A
HH
D
D
G
QQ
ZZ