Makita XCC01 Manual De Instrucciones página 10

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1
► 1. Hex wrench
Removing and installing diamond
wheel
CAUTION:
Use only the Makita hex wrench
supplied to remove and install a diamond wheel.
CAUTION:
When installing a diamond wheel,
be sure to tighten the bolt securely.
CAUTION:
Always install a diamond wheel so
that the arrows on the diamond wheel point in the
same direction as the arrows on the wheel cover
and gear housing. Otherwise the wheel rotates in
reverse, it may cause personal injury.
To remove the diamond wheel, press the shaft lock
fully so that the diamond wheel cannot revolve and use
the hex wrench to loosen the hex bolt clockwise. Then
remove the hex bolt, outer flange and diamond wheel.
2
1
► 1. Shaft lock 2. Hex wrench 3. Hex bolt 4. Loosen
5. Tighten
5
4
3
NOTICE:
If the inner flange is removed, install it on
the spindle with its wheel mounting part facing the
diamond wheel.
To install a diamond wheel, follow the removal pro-
cedure in reverse. Make sure the diamond wheel is
installed so that the arrows on the wheel point in the
same direction as the arrows on the wheel cover and
gear housing.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
6
1
2
4
5
► 1. Hex bolt 2. Outer flange 3. Diamond wheel
4. Inner flange 5. Cup washer 6. Arrow
Water supply tank
CAUTION:
When filling the tank with water, be
careful not to spill water over the tool.
CAUTION:
Be sure that the water supply lever
on the wheel cover is set in the "OFF" (O) position
before installing the water supply tank.
10 ENGLISH
1
2
3
6
4
3