Filling The Water Reservoir - Sunbeam Simple Press 3010 Manual Del Usuario

Filling the Water Reservoir

You must fill the water reservoir with water to use
the SPRAY MIST8 and SHOT OF STEAM features
and to
get steam out
Tip: Sunbeam tests each iron at the factory to
ensure that they function correctly. The test may
leave a small, harmless amount of water within
the water reservoir.
Before you fill the water reservoir, please consider
the following:
While this iron was designed for use with tap
l
water, very hard water will reduce the performance
of the iron. If your water is very hard, Sunbeam
recommends that you use tap water the first time,
then consider using demineralized or distilled water
for subsequent use. You should use tap water once
a month, however, to maintain the iron's optimal
steam performance.
.
Do use water that has passed through a home
not
water softening system. This type of water contains
minerals that will decrease the performance and
shorten the life of your uon. Use demineralized or
distilled water,
When not ironing
Important:
Control and the Fabric Select dial to OFF.
To fill the water reservoir:
1. Make sure the Iron is unplugged and that both
the Fabric Select dial and the
set to OFF.
of your iron
instead.
always set the Steam
Steam
Control are