Stanley Fatmax FME650 Traducción De Las Instrucciones Originales página 7

Assembly
Fitting and removing the accessories (fig. A - G)
Warning! Before fitting an accessory, disconnect the tool from
the mains supply.
Fitting a Stanley Fat Max accessory (fig. A - C)
Hold the tool and squeeze the accessory clamping lever
u
(3).
Slide the accessory (9) between the shaft and the acces-
u
sory holder making sure the accessory engages all eight
pins on the holder and is flush with the shaft.
Release the accessory clamping lever.
u
Note: Some accessories, such as scrapers and blades can be
mounted at an angle if required (fig. C).
Removing a Stanley Fat Max accessory accessory (fig. A)
Hold the tool and squeeze the accessory clamping lever
u
(3).
Pull the accessory from the tool making sure the acces-
u
sory dis-engages from all eight pins on the holder.
Release the accessory clamping lever.
u
Warning: Gloves must be worn when removing accessories
as then may become hot during use.
Carbide grout removal blade.
(Part number - STA26125-XJ)
Carbide coated surface ideal for
clearing grout and tile adhesive from
flat surfaces and for fast stock
removal of wood, chipboard and
fibreglass.
Carbide rasp.
(Part number - STA26130-XJ)
Carbide coated surface ideal for grout
removal and for fast stock removal of
plastics, chipboard and fibreglass.
Sanding Sheets.
(Part number - STA32348-XJ)
Various grades for sanding of wood,
painted and varnished surfaces.
(Original instructions)
Fitting a sanding sheet (fig. D)
Line up the sanding sheet (10) with the sanding base (4)
u
as shown.
Press the sheet firmly and evenly onto the sanding base,
u
making sure that the holes in the sheet coincide with the
holes in the base.
Removing a sanding sheet
Pull the sanding sheet off the sanding base (4).
u
Warning! Never use the sanding base without a sanding
sheet or accessory in place.
Fitting the dust extraction adaptor (fig. E)
Line up the dust extraction adaptor (5) with the sanding
u
base (4) as shown.
Press the adaptor firmly and evenly in to the sanding
u
base.
Secure the adaptor by turning the locking nut (11) clock-
u
wise.
Connect a vacuum cleaner to the dust extraction adaptor.
u
Removing the dust extraction adaptor
Turn the locking nut (11) anti-clockwise.
u
Pull the dust extraction adaptor (5) out of the sanding
u
base (4).
Fitting the depth/cut guide (fig. F)
The depth/cut guide allows you to precisely cut material at a
specified depth and more accurately track a marked cut line.
Attach the depth/cut block (8) by inserting the tabs on the
u
guide into the slots on the main body.
Secure the block to the main body with the bolt (12) and
u
tighten with the supplied hex wrench.
Insert the guide (13) into the requried position and secure
u
by turning the depth/cut adjustment knob (14) clockwise.
Fitting alternative accessories (fig. G)
Place the spacer (6) onto the collar (15).
u
Place the alternative accessory (16) onto the collar (15).
u
Firmly attach the fixing bolt (7) into place to ensure a tight
u
fit for the alternative accessory (16).
Note: The spacer and fixing bolt are not used to attach
Stanley Fat Max accessories. Stanley Fat Max accessories
are attached using the Super-lok
ing lever.
ENGLISH
Tool free accessory clamp-
TM
7