RotoZip SS560VSC Instrucciones De Funcionamiento página 22

RZ 2610021432 10-12_RZ 2610021432 10-12.qxp 10/30/12 9:57 AM Page 22
When making a cut in sheet metal, masonry,
etc.: You may start your cut at the end of the
piece or you can plunge cut somewhere in
the body of the material.
STRAIGHT CUT APPLICATION
FOOT
FLUSH CUTTING APPLICATION
Consider the desired height of the flush cut.
For flooring installation, add up the thickness of
your flooring adhesive, the flooring itself, and
any underlayments or other material that will
add to the thickness of the finished floor. Also
note that this saw will create a cut
approximately 3/4" deep.
This saw creates a cut approximately 3/16"
above the surface where the guard is resting.
When cutting door jambs, baseboard, toe kicks,
or other areas where flooring needs to slide
underneath, raise the saw's cutting height by
placing a piece of scrap material underneath
the guard to act as a resting surface. Make
sure your scrap material runs along the entire
length of the area to be cut (Fig. 10).
Turn the tool on and wait for the wheel to reach
full speed.
In order to try to avoid recoil (a situation where
the wheel wants to skip out of the material) it
is recommended to make cuts in the same
direction as the rotation of the wheel (Fig. 9).
DIRECTION OF
CUT
WHEEL DIRECTION
Carefully plunge the wheel into the workpiece,
making sure to keep the guard in constant
contact with the resting surface. In order to
ensure a smooth cut, make your cut from left to
right.
-22-