Led Lights - Tripp-Lite B170-004-R Manual De Instrucciones

Features:
•
Reversible – use for multiple computers to one printer, or one computer to multiple printers.
•
Supports IEEE-1284 nibble mode.
•
Share Peripherals between computers.
•
Emulates printer response
•
Compatible with HP, NEC, Epson and other bi-directional printers
•
Port can be selected manually (or via software when sharing a printer)
•
Selectable timeout; 15 or 45 seconds.
•
Operates on a First-come First-served basis.
•
No AC power required
•
Supports broadcast mode.
Installation:
1. Turn off all devices being connected to the switch.
2. Connect a PC to the Switch using an IEEE straight through cable DB25 Male/Male (Tripp Lite # P710-006, or P710-010).
3. Connect a parallel device to the Switch using an IEEE Printer Cable DB25 to Cen36 Male/Male (Tripp Lite # P606-003,
P606-006 or P606-010).
4. Set the DIP switches located on the end of the autoswitch using the chart under the unit as a guide:
Switch #1 should always be set to Normal
For multiple PCs to 1 Printer, set Switch #3 to the 4-to-1 setting and set Switch #4 to the desired Time Out.
For 1 PC to multiple Printers, set Switch #3 to the 1-to-4 setting
5. Turn on all devices.

LED Lights

When used to share a printer, the LED's should flash alternately as the Auto Switch scans for print jobs.
When used to connect a PC to multiple devices, LED A should light as you select port A
Specifications:
Function
Power Consumption
Maximum Cable Length
Input Port Selection
Output Port Selection
Timeout
Broadcast
Operation:
4-to-1 Mode
Auto Mode:
The switch automatically scans all input ports for print jobs. Flashing LEDs indicate that the switch is in the Auto mode.
When a print job is detected, the switch locks on the active input port and blocks all other print jobs. After printing is
completed, the switch releases the port and starts to scan all ports for another print job.
Manual Mode:
Each time the manual button on the end is pressed, the active port moves to the next port in the following order:: A
D E Auto
ONLY port that can print. The port cannot be changed during a print job or during the timeout period.
1-to-4 Mode
Selecting the printer manually:
Ports activate in the following order: A
and will proceed to the next setting each time the button on the top is pushed.
1-to-4 Mode
Software or Manual Selection
Available
A. The illuminated LED indicates which port is active. When a port is selected manually, it is the
B D
Insert 1-to-4 and 4-to-1 Diagrams
9V DC 50mA (max.)
20ft per cable
- Automatic or Manual Selection
- 15 or 45 seconds
E Broadcast (ALL) A. The cycle begins with the current port
4-to-1 Mode
-
-
B