Mounting The Cutting Blade - TRAPP Master 1000 Manual De Instrucciones

Hold the protection skirt (1), fit it into the
guiding-hole (2) on the aluminium bar of the
transmission gearbox, place the footstrap (3), the
bolts (4) and tighten them.
Warning!
✔
Never operate your mower without the
protection skirt, specially if you are using
the nylon spool, because then you won't
have the limiting blade for the cutting
area and the motor will burn from
overcharging.
✔
Using the equipment without the
protection skirt is considered loss of
warranty.
✔
Make sure that the on/off key is in the "off"
position and that the cord is disconnected
from the power supply.
✔
Place the equipment carefully on a flat
surface positioning the blade face-up and the
handlebars face-down.
4
5
6
7
3
2
Mounting the protection skirt

Mounting the cutting blade

8
1
4
✔
Then put the locking pin (1) in the adjusting
hole on the washer (2) to coincide with the
hole on the blade's support base (3) to lock it
into place. Use the blade's mounting key (4)
to loosen the mounting nut (5), observing that
the threading is on the left. Remove the lock
washer (6), the plain washer (7) and place the
blade (8).).
✔
To mount follow the reverse order in the same
sequence.
Warning!
✔
Never hold the blade when you have to
tighten or loosen the mounting nut - you
might get badly hurt.
✔
Never use blades with external diameter
over 255 mm.
✔
When using the nylon filament spool obey
the maximum filament length (10 cm).
Out of specification length can lead to
motor burning and loss of warranty.
✔
The cutting blade's fitting hole measures 1
inch (25.4 mm).
1
2
3
29