TFA 65.5016 Instrucciones De Uso página 13

TFA_No. 60.5016_Anleitung 18.04.2019
Radio-controlled projection alarm clock with thermometer
5. Elements
5.1 LCD display (Fig. 1)
A 1: Time with seconds, DCF reception symbol, alarm symbol
A 2: Alarm time / date, day of the week, indoor temperature
5.2 Buttons (Fig. 1-3)
B 1: MODE / SET button
B 3: ALARM button
B 5: °C/°F button
B 7: Projection HIGH/LOW/OFF button
5.3 Housing (Fig. 2+3)
C 1: Battery compartment
C 3: Projection arm
5.4 Projection (Fig. 4)
D 1: Indoor temperature
D 3: A/P in 12-hour-format
24
13:06 Uhr Seite 13
B 2: DIMMER ▲ / ▼ buttons
B 4:
WAVE 12/24 button
B 6: RESET button
B 8: SNOOZE/LIGHT button
C 2: Power socket
C 4: Dial for focus
D 2: Time
D 4: Alarm symbol (if alarm is activated)
Radio-controlled projection alarm clock with thermometer
6. Getting started
• The projection alarm clock can be operated with 2 x 1,5 V AA batteries (not included). The batteries
maintain the clock operation in the event of blackout or other power failure. In pure battery operation, the
backlight and projection are activated briefly when the SNOOZE/LIGHT button is pressed. For a permanent
backlight and projection and to conserve battery power, use the supplied power adapter.
• Insert the power adapter pin into the device jack and connect the plug to a wall socket.
• Important! Make sure that your household voltage is no more than 230V! Otherwise your device may be
damaged.
• The device is ready for use.
• The device will alert you with a beep and all segments will be displayed for a short moment.
• Optional: Open the battery compartment and insert two new AA 1.5 V batteries, polarity as illustrated.
• Close the battery compartment again.
• The clock will now scan the DCF frequency signal and the DCF symbol will be flashing on the display.
When the time code is successfully received after 3-5 minutes, the radio-controlled time and the DCF
symbol will be shown steadily on the display.
• If the reception fails, activate the reception manually by holding
• Interrupt the reception by pressing the WAVE 12/24 button again for three seconds.
• The time is updated every day at 2 and 3 o'clock in the morning.
• If the clock cannot detect the DCF-signal (e.g. due to interference, transmitting distance, etc.), the time
can be set manually. The clock will then work as a normal quartz clock. (see: Manual setting of the clock
and calendar).
WAVE 12/24 button for 3 seconds.
25