Setting Up The Nursery Unit - Angelcare AC117 Manual De Usuario

2.2 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
IMPORTANT
• If your crib does not have a solid, stationary, completely flat, firm surface including
a spring or slat base, place a hard board between the crib base and the Sensor Pad,
to ensure correct operation. The hardboard support must measure at least 33 x 33
cm (13" x 13") and 6 mm (1/4") thick. This hardboard support must be larger than the
Sensor Pad surface area.
• The Sensor Pad functions with any size and type of mattress except memory-foam mattresses, hollow
frame mattresses and water beds. The hardboard maintains a constant pressure on the Sensor Pad,
enabling it to detect the baby's movements even when the baby is at the edges of the crib.
IMPORTANT!
• Ensure the Sensor Pad is in the center of the Crib – printed or Logo side up – on top of the
hardboard. Check the position is central before each use.
• BEFORE FIRST TIME USE: Test that the unit is ready for use – refer to to the Full User Manual
to check installation is correct.
STEP 3 - SETTING UP THE NURSERY UNIT
3.1 - SELECT A LOCATION FOR THE NURSERY UNIT
IMPORTANT
Place the crib near a supporting wall and far from air currents. Install the Nursery Unit on a flat, stable
surface facing the crib at a distance of at least 3 feet (1 meter). Make sure to plug the adapter to the
socket outlet nearest to the equipment and that is easily accessible.
6
Sensor Pad
1) Remove the mattress from the crib.
2
2) Place the Sensor Pad - Angelcare
side up - in the center of the mattress.
It should be centered on the hardboard
if your crib requires a hardboard
support.
3) Replace the mattress.
Hardboard
logo
®