Starting The Machine; Stopping The Machine - Makita HTR5600 Manual De Instrucciones

STARTING THE MACHINE

Move at least 3 meters away from the place of refuelling. Place the
Hedge Trimmer on a clean area of ground make sure that the cutting
tool does not come into contact with the ground or any other objects.
Cold starting (When the engine is cold or it has been stopped for
more than 5 minutes or when fuel is added to the engine.
1. Push the I-O Switch (1) to "I" position.
2. Give a gentle push on the primer pump (2) repeatedly (7 to 10
times) until fuel comes into the primer pump.
3. Move the choke lever (3) to position "START".
4. Hold the unit down firmly so you will not lose control while
cranking the engine. If not held down properly, the engine could
pull you off balance or swing the cutting blade into an obstruction
or your body.
5. Pull the starter handle solely for 10 to 15 cm, and check the
location of pressure.
6. Pull strongly when pressurization can be felt and start the engine.
7. When the engine starts, return the choke lever to "Run". Please
note that the choke lever will return to "Run" position
automatically when the throttle lever is operated and the
throttle is opened.
8. Run the engine for approximately one minute at a moderate
speed before aplying full speed.
Note: If the starter handle is pulled repeatedly when the choke
lever remains at "Start" position, the engine will not start
easily due to excessive fuel intake.
In case of excessive fuel intake, remove the spark plug
and pull the starter handle slowly to remove excess fuel.
Also, dry the electrode section of the spark plug.
Hot staring: (Restarting immediately after the engine has stopped)
When restaring a hot engine, first try the above procedure: 1, 4, 5, 6.
If the engine does not start, repeat above steps 1-8.
Note: Do not pull the starter rope to its full extent and do not
allow the starter grip to be retracted without control,
ensure that it is retracted slowly.

STOPPING THE MACHINE

1. Release the throttle lever completely.
2. Push the STOP Switch (on/off switch) to "O"
position, the engine rotation will become low
and the engine will stop.
10
(1)
HTR7610
(2)
(3)
HTR7610
HTR5600
START
RUN
HTR5600