Tabla de contenido
Idiomas disponibles
Idiomas disponibles
USING PNEUMATIC SANDBLASTER
Attention: Before filling the tool's bag (9) or changing any other settings, the device must be
disconnected from the compressed air supply.
Note: Only use compatible blasting material for your sandblasting work.
We recommended using blasting material with no risk of silicosis (ground blast furnace slag) with a
grit size of 46 to 100.
1. Ensure that the blasting material is absolutely dry and not too coarse-grained.
2. Press the clamp (8) and remove the tool's bag (9).
3. Fill up about 1/3 of the tool's bag (9) with blasting material. Take care, do not overfill.
4. Press the clamp (8) and install the tool's bag (9) to the pneumatic sandblaster.
5. Connect the pneumatic sandblaster to your air supply.
6. Press the trigger lever (15) to start using the pneumatic sandblaster.
7. Release the trigger lever (15) to switch off the pneumatic sandblaster.
MAINTENANCE
Always disconnect the device from the compressed air supply before cleaning, maintaining or
repairing. Clean the pneumatic sandblaster and the sandblasting material bag after completing your
work. Use compressed air to blow through the pneumatic sandblaster and the sandblasting material
bag. Always store the pneumatic sandblaster in a dry place.
TROUBLESHOOTING
FAULTS
Material does
not flow freely
Sandblasting
Finish is not
as expected
When there are other faults, please contact to a sandblasting professional or your local store.
ENVIRONMENTAL PROTECTION
Dispose of this product at the end of its working life environmentally.
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and disposed
of in a manner which is compatible with the environment. Contact your local solid waste
authority for recycling information.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
POSSIBLE CAUSE
Air is not dry enough.
Air pressure too low
Attachment not
properly seated
Clogged sandblasting
material supply line(s)
Air is not dry enough
Size of the sandblasting
material is not uniform
Sandblasting material
is contaminated
The attachment is worn
Tel.: 02196 720480
Fax.: 02196 7204820
SOLUTION
Fit a water separator (water trap)
to your compressed air system.
Increase the output pressure
on your compressor.
Ensure that the attachment is
fitted firmly to the device and that
no air can escape at the sides.
Check that clumps of sandblasting material
are not clogging the supply lines.
An air blow gun is the best tool for cleaning
any clogged supply lines.
(Wear protective goggles!)
Check the outlet on the tank.
Fit a water separator (water trap)
to your compressed air system.
Replace the sandblasting material.
Sandblasting material should
be cleaned/replaced.
Replace the attachment
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
