Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SAFETY WHILE OPERATING
Take enough time for a careful selection of a working area. Take care that your workplace is near to
the compressor and blasting material. Attention! Always stay aware. Remove the device or other
objects from the working area. Persons and animals must not remain in the working area. Never
direct the air tool against persons or animals. Always wear safety equipment like safety glasses and
dust masks when working with this air tool (see chapter "Occupational Safety").
COMPONENTS
No.
1
Handle
2
Nut
3
Body
4
Stationary Seat
5
Air Nozzle
6
Guide Pipe
7
Hose
8
Clamp
9
Bag
10 Surface Spot Nozzle
11 Panel Spot Nozzle
12 Outside Corner Nozzle
PREPARING WORKPIECE
•
Clean and degrease your workpiece. Dust and grease deposits will significantly impair your
results.
Carefully cover up or mask off anything that should not be sandblasted.
•
•
The distance from the attachment to your workpiece is critical for the end result.
Keep the distance as short as possible, to ensure that the collecting bag (9) can catch all of the
•
material.
•
The closer you get to your workpiece, the smaller the blasting radius on the workpiece itself, and
vice versa.
To check results beforehand, you can perform a test run on a piece of scrap material, this helps
•
you to identify the right distance/working pressure and avoids excessive sandblasting of your
actual workpiece.
SELECTING AND FITTING ATTACHMENT
Select the accessories (10/11/12/13) that are best for the job being done.
Fit your chosen attachment firmly to the blasting nozzle (6), taking care to ensure that no air can
escape at the sides.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Description
Tel.: 02196 720480
Fax.: 02196 7204820
No.
Description
13
Inside Corner Nozzle
14
Rivet
15
Trigger Lever
16
Spring
17
Valve Stem
18
Rubber Washer
19
Valve Bushing
20
O-Ring
21
Lock Nut
22
O-Ring
23
Air Inlet
24
Template
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
