Sony MEX-N5200BT Manual De Instrucciones página 29

BLUETOOTH function
The connecting device cannot detect this
unit.
 Before the pairing is made, set this unit to
pairing standby mode.
 While connected to two BLUETOOTH
devices, this unit cannot be detected from
another device.
– Disconnect either connection and search
for this unit from another device.
 When the device pairing is made, set the
BLUETOOTH signal output to on (page 9).
Connection is not possible.
 The connection is controlled from one side
(this unit or BLUETOOTH device), but not
both.
– Connect to this unit from a BLUETOOTH
device or vice versa.
The name of the detected device does not
appear.
 Depending on the status of the other
device, it may not be possible to obtain
the name.
No ringtone.
 Adjust the volume by rotating the control
dial while receiving a call.
 Depending on the connecting device, the
ringtone may not be sent properly.
– Set [RINGTONE] to [1] (page 21).
 The front speakers are not connected to
the unit.
– Connect the front speakers to the unit.
The ringtone is output only from the
front speakers.
The talker's voice cannot be heard.
 The front speakers are not connected to
the unit.
– Connect the front speakers to the unit.
The talker's voice is output only from the
front speakers.
A call partner says that the volume is too
low or high.
 Adjust the volume accordingly using Mic
gain adjustment (page 15).
Echo or noise occurs in phone call
conversations.
 Lower the volume.
 Set EC/NC Mode to [EC/NC-1] or [EC/NC-2]
(page 15).
 If the ambient noise other than the phone
call sound is loud, try reducing this noise.
E.g.: If a window is open and road noise,
etc., is loud, shut the window. If an air
conditioner is loud, lower the air
conditioner.
The phone is not connected.
 When BLUETOOTH audio is played, the
phone is not connected even if you press
CALL.
– Connect from the phone.
The phone sound quality is poor.
 Phone sound quality depends on
reception conditions of cellular phone.
– Move your car to a place where you can
enhance the cellular phone's signal if
the reception is poor.
The volume of the connected audio device
is low (high).
 Volume level will differ depending on the
audio device.
– Adjust the volume of the connected
audio device or this unit (page 20).
The sound skips during playback of a
BLUETOOTH audio device.
 Reduce the distance between the unit and
the BLUETOOTH audio device.
 If the BLUETOOTH audio device is stored in
a case which interrupts the signal, remove
the audio device from the case during use.
 Several BLUETOOTH devices or other
devices which emit radio waves are in use
nearby.
– Turn off the other devices.
– Increase the distance from the other
devices.
 The playback sound stops momentarily
when the connection between this unit
and the cellular phone is being made. This
is not a malfunction.
The connected BLUETOOTH audio device
cannot be controlled.
 Check that the connected BLUETOOTH
audio device supports AVRCP.
29
GB