Husqvarna R 214T Manual De Usuario página 16

1. PREPARE THE PRODUCT
Do a check of the belts and pulleys.
Do a check of the steering chain of the inner side of the frame tunnel.
Do an inspection, lubricate and adjust all wires.
Make sure that the tire pressure is correct. Refer to
Make sure that all screws and nuts are tightened with the correct torque.
Lubricate the operators seat.
Lubricate all chains.
Lubricate the wheels and blade bearings on the cutting deck.
Lubricate the pedals on the inner side of the frame tunnel.
Lubricate the belt tensioner.
Remove the drive wheels and grease the axels.
2. ENGINE
Do a check of the fuel hose. Replace if it is necessary.
Replace the fuel filter. Refer to
Replace the air filter. Refer to
Do an inspection of the cooling fins on the hydrostatic transmission.
Clean the engine and the hydrostatic transmission.
Do a check of the muffler and the heat deflector.
Replace the engine oil. Refer to
26 .
Replace the engine oil filter. Refer to
page 26 .
Replace the spark plug. Refer to
20 .
Do a check on the lights (if applicable).
Update the firmware (if applicable).
Do a check of the battery and charge if it is necessary.
16
Tire pressure on page 22 .
To replace the fuel filter on page 19 .
To remove and install the air filter on page 20 .
To replace the engine oil and oil filter on page
To replace the engine oil and oil filter on
To examine and replace a spark plug on page
First Maintenance interval
servicing in hours
50 100
O O
O
O
O O
O
O
O
O O
O
O
O
First Maintenance interval
servicing in hours
50 100
O
O
Clean O
O
O
O O
100
hours or
O one (TN)
time each
year
O O
O
O O
O O
O O
1686 - 001 - 03.11.2021
200
200