Makita UR100D Manual De Instrucciones página 8

Adjusting the position of the handle
and front grip
CAUTION:
Before adjusting the shaft length,
be sure to switch off the tool and remove the
battery cartridge from the tool. Failure to do so may
cause a personal injury.
Adjust the length of the shaft so that you can hold the
handle when lowering your right hand.
1
► 1. Handle
To adjust the shaft length, open the lock lever, then
adjust the length of the shaft, and then close the lock
lever.
► 1. Lock lever
Adjust the position of the front grip so that you can hold
the front grip when lowering your left hand.
1
► 1. Front grip
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
Never start the tool unless it is
completely assembled. Operation of the tool in a
partially assembled state may result in serious per-
sonal injury from accidental start-up.
Installing the front grip
Attach the front grip to the front grip holder and secure
it with a hex bolt and the thumb nut as shown in the
figure.
1
2
► 1. Front grip 2. Thumb nut 3. Hex bolt
The front grip angle is adjustable. To adjust the front
grip angle, loosen the thumb nut, set the front grip at an
proper angle according to your work and then tighten
the thumb nut clockwise firmly.
8 ENGLISH
1
3