Makita UR100D Manual De Instrucciones página 10

2. Insert the hex wrench through the hole on the
motor housing and rotate the spindle until the spindle is
locked.
► 1. Hex wrench 2. Hole 3. Spindle
3. Place the nylon cutting head onto the spindle and
tighten it by turning it clockwise.
► 1. Nylon cutting head
4. Remove the hex wrench.
To remove the nylon cutting head, turn it counterclock-
wise while locking the spindle with the hex wrench.
Attaching the shoulder harness
1
► 1. Hook
3
2
1
Attach the hooks of the shoulder harness to the tool as
shown in the figure.
CAUTION:
shoulder harness to the tool securely. If the hooks
are attached incompletely, they may come off and
cause injury.
Hex wrench storage
CAUTION:
wrench inserted in the tool head. It may cause
injury and/or damage to the tool.
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1
► 1. Hex wrench
OPERATION
Cutting the grass
Hold the grass trimmer at the angle of about 50° to the
ground. Move the grass trimmer from right to left slowly.
Cut the grass a few times from the top of the grass at
the tip of the nylon cord.
NOTICE:
the high grass at a time near the root may cause the
nylon cutting head to be entangled by grass. This
may cause the motor overload, resulting in damage to
the grass trimmer.
NOTICE:
the spool into a contact with the ground surface.
Using the spool contacting the ground surface may
cause the motor under overload resulting in damage
to the grass trimmer.
10 ENGLISH
Be sure to attach the hooks of the
Be careful not to leave the hex
Do not cut high grass at a time. Cutting
Use the grass trimmer without getting
1