Troubleshooting - Craftsman 151.74580 Manual Del Usuario

PROBLEM
Line will not advance
when using the auto-
feed head.
Grass wraps around
shaft and spool
head.
Motor fails to start
when power switch
is depressed.

TROUBLESHOOTING

POSSIBLE CAUSE
1. Line is welded to itself. 1. Lubricate with silicone spray.
2. Not enough line on
spool.
3. Line is worn too short.
4. Line is tangled on
spool.
1. Cutting tall grass at
ground level.
1. Battery is not secure.
2. Battery is not charged.
19 ― English
SOLUTION
2. Install more line. Refer to LINE
REPLACEMENT section in this manual.
3. Remove battery pack. Push advance
button on spool head while pulling on line
manually.
4. Remove line from spool and rewind.
Refer to LINE REPLACEMENT section in
this manual.
1. Cut tall grass from the top down to
prevent wrapping.
1. To secure the battery pack, make sure
the tongue of the battery pack aligns with
the cavity in the housing and snaps into
place.
2. Charge the battery pack according to
the instructions in this manual.