EINHELL TC-DH 1600/1 Manual De Instrucciones página 24

hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Check the drilling point for concealed electrical
cables, gas and water pipes using a cable/pipe
detector.
5.1 Additional handle (Fig. 2)
For safety reasons you must only use the
demolition hammer with the additional
handle. The additional handle (3) enables you to
achieve better stability whilst using the demolition
hammer. The additional handle (3) can be turned
into any required position. Undo the screw (a) by
turning it in the "+" direction. Now turn the additio-
nal handle (3) into the most comfortable working
position for yourself and then tighten the screw (a)
again by turning it in the "-" direction.
5.2 Tool insertion (Fig. 3-4)
•
Clean the tool before fitting it and apply a thin
coating of grease to the tool shaft.
•
Pull out the locking bolt (4) as far as possible,
turn it through 180° and release it.
•
Insert the tool into the tool mounting (5) and
push it in as far as possible. (see Fig. 3)
•
Pull out the locking bolt (4) again, turn it
through 180° in the opposite direction and
release it.
•
Check the lock by pulling the tool.
5.3 Removing the tool
To remove the tool, proceed in reserve order.
Anl_TC_DH_1600_1_SPK8.indb 24 Anl_TC_DH_1600_1_SPK8.indb 24
GB
6. Operation
Important.
To avoid danger, the machine must only be
held using the two handles (1/3). Otherwise
you may suff er an electric shock if you chisel into
cables.
6.1 Switching On and Off (Fig. 5)
Switching on:
Press the On/Off switch (2)
Switching off :
Press the On/Off switch (2) briefl y or let go.
6.2 Practical tips
6.2.1 Sharpening chisel tools
You will only achieve good results if you use sharp
chisels. You should therefore sharpen the chisels
promptly to ensure that they produce good results
and provide a long service life.
Notice!
You only require slight contact pressure for chi-
seling. Excessive contact pressure will place an
unnecessary strain on the motor. Check the chi-
sels at regular intervals. Sharpen or replace blunt
chisels.
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
- 24 -
08.03.16 11:02 08.03.16 11:02