Connecting The Inverter - Waeco PerfectPower PP1002 Instrucciones De Montaje Y De Uso

_PP1000_PP2000.book Seite 33 Donnerstag, 16. Oktober 2008 4:53 16
PerfectPower
Fasten the inverter as follows (fig. 5, page 4):
Caution
a
Before drilling any holes, make sure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
➤ Clip two holders on the left bar and two on the lower right bar.
You can move the holders as required.
➤ Fasten the inverter by screwing one screw through each hole in the
holder.
8.2

Connecting the inverter

Caution
a
The inverter may only be connected by a qualified workshop.
The following information is intended for specialists who are
familiar with the guidelines and safety precautions to be applied.
Observe the following safety instructions for the electrical connections:
Caution – Risk of short circuit!
e
When working on the vehicle, always disconnect the earth
connection to the supply battery.
Disconnect the 230 V external power supply to the caravan.
If you have to feed cables through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
Do not lay cables which are loose or bent next to electrically
conductive material (metal).
Fasten the cables securely.
Do not pull on the cables.
Do not lay the 230 V mains cable and the 12/24 V DC cable in
the same duct.
Lay the cables so that they cannot be tripped over or damaged.
www.busse-yachtshop.de | [email protected]
Fastening and connecting the inverter
33