Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Collected_MB-815_rev1_q6.qxd
1. Inverter with connecting cable
2. operating instructions
The connection is to be made via a plug
which can be plugged into a 12 V cigarette
lighter mains socket. The medium pin of the
plug is connected with the (+) positive line
and the two lateral brackets of the plug are
connected with the (-) negative line. Take
care that there is a firm connection when
inserting the plug into the cigarette lighter
mains socket. The plug heats up when there
is an insufficient connection.
1
230 V AC output
2
"ON/OFF" control light-emitting
diode green
3
ON/OFF switch
4
control light-emitting diode red
(overload- and undervoltage
display)
5
positive contact
6
negative contact
Attention! The load capacity of the cigarette
lighter mains socket, the supply line and the
fuse protection must amount to at least 15
ampere. The fuse protection must not be
increased without authorisation.
The start-up can be done with the "ON/OFF"
switch. The green control light-emitting diode
"POWER" lights up in the switch position "ON".
An alarm tone sounds and the red control light-
emitting diode lights up if
voltage drops during the operation under 10.7 V
for 815-012PP or 12.4 V for 815-024PP . The
inverter switches off if the battery voltage drops
further. When the heating is too strong, the
inverter switches off — the red control light-
emitting diode illuminates. Switch off the inverter
by means of the "ON/OFF" switch. The inverter
can be switched on again after it has cooled
down. When operating the Pocket Power during
longer period of time and with the largest load, it
is recommendable to start the motor in order to
08.06.2004
16:08 Uhr
Scope of delivery
Installing the inverter
Commissioning of the inverter
recharge the battery of the vehicle. The inverter
can be operated with the motor running or
switched off. However, the motor should not be
started if the Pocket Power is switched on, since
the battery
the power supply to the cigarette lighter could
be interrupted during the start process.
8
Seite 8
1
2
3
4
5
6
Tabla de contenido
