Worx WG782 Manual Del Usuario página 17

8. rEar diSCharGE (See l)
The mower provides a rear discharge function,
so that you can mow collecting or mulching
the grass. Grass clippings will be discharged
from the rear chute of the mower and exit
below the safety flap.
9. mowiNG TiPS
NoTE: always inspect area where mower
is to be used and remove all stones,
sticks, wire, metal and other debris
which might be thrown by the rotating
blade.
1) Mow across the face of slopes, never up-
and-down. Exercise extreme caution when
changing direction on slopes. Do not mow
excessively steep slopes. Always maintain
good footing.
2) Release switch lever to turn mower "OFF"
when crossing any graveled area (stones
can be thrown by the blade).
3) Set mower at highest cutting height when
mowing in rough ground or in tall weeds.
Removing too much grass at one time can
cause circuit breaker to trip, which stops
mower.
4) If a grass bag is used during the fast
growing season, the grass may tend to clog
up at the discharge opening. Release switch
lever to turn mower "OFF" and remove
the safety key. Remove the grass bag and
shake the grass down to the back end of
the bag. Also clean out any grass or debris
which may be packed around the discharge
opening. Replace the grass bag.
5) If mower should start to vibrate abnormally,
release switch lever to turn mower "OFF"
and remove safety key. Check immediately
for cause. Vibration is a warning of trouble.
Do not operate mower until a service check
has been made.
6) always release switch lever to turn
mower "off" and remove safety key
when leaving it unattended even for a
short period of time.
10. mUlChiNG mowiNG TiPS
While mulching, your new mower is designed
to cut the grass clippings into small pieces
24V 14" Cordless lawn mower
and distribute them back into the lawn.
Under normal conditions, the mulched grass
will biodegrade quickly to provide nutrients
to the lawn. Please review the following
recommendations for optimum mulching
performance.
1) Avoid mowing when the grass is wet from
rain or dew. Wet grass may form clumps
which interfere with the mulching action
and reduce runtime. The best time to mow
grass is in the late afternoon when the
grass is dry and the newly cut area will not
be exposed to direct sunlight.
2) For best mulching performance, set the
cutting height to remove about one third
of the grass blade length, ideally no more
than 1.5" (38mm) at one time. If the lawn is
overgrown, it may be necessary to increase
the cut height to reduce the pushing effort
and prevent overloading the motor. For
extremely heavy mulching, it is advisable
to first cut at a high cut height setting,
and then re-cut to the final cut height.
Otherwise, make narrower cuts and mow
slowly.
3) For best performance, keep the mower
housing free of built-up grass. From time to
time turn off mower and wait for the blade
to come to a complete stop. Then unplug
the safety key and turn mower on its side.
Using an object such as a stick, wipe out
any accumulation of grass in the blade
area. Be careful of the sharp edges of the
blade. Clean often in wet, new grass, and
always after every use.
4) Certain types of grass or grass conditions
may require that an area be mulched a
second time to fully disperse the grass
throughout the lawn. If cutting a second
time, it is advisable to cut perpendicular
(across) the first cut pattern. DO NOT
CHANGE CUT PATTERN IN ANY WAY THAT
WOULD CAUSE MOWING DOWN AHILL.
5) Change your cutting pattern from week to
week. This will help prevent matting and
graining of the lawn.
17 17
EN