Tabla de contenido
Idiomas disponibles
Idiomas disponibles
gas adustment
1
Injector
2
Adjustme n n t of minimum l e e vel of the flam e e
injector in place.
Tu u rn the taps down to minimum
R R emove the knob from the tap and place a small
Control handle
bladed screwdriver in the centre of the tap shaft.
The correct adjustment is obtained when the flame
Tap
has a length of about 3 - 4 mm.
Sealing ring
For butane propane gas, the adjusting screw
‐
must be tightly screwed in.
Refit the control knob.
‐
‐
M
turning
does then remove the control knob and make further
adjustments to the gas flow, testing it again once the
adjustment has been made.
Repeat this process for each one of the gas taps.
/
ake sure that the flame does not go out by quickly
from maximum flow to minimum flow. If it
GB-20
Tabla de contenido
