DRIJA MILAN 76 Manual De Instrucciones página 39

positioning
o The edges of the hob must be a minimum distance of
rear wall.
o 700 mm between the highest point of the hob surface (including the burners)
and the underside of any horizontal surface directly above it.
o 400 mm between the hob surfaces, providing that the underside of the
horizontal surface is in line with the outer edge of the hob. If the underside of
the horizontal surface is lower than 400 mm, then it must be at least 50 mm
away from the outer edges of the hob.
o 50 mm clearance around the appliance and between the hob surface and any
combustible materials.
o You must have a gap of at least 25 mm and at most 74 mm between the
underneath of the appliance and any surface that is below it.
- An oven must have forced ventilation to install a hob above it.
- Check the dimensions of the oven in the installation manual.
- The cut out size must obey the indication.
appliance upside down and place it on a cushioned mat.
operation.
2. Apply the sponge provided around the edge of the appliance.
3. Do not leave a gap in the sealing agent or overlap the thickness.
750
750
Bottom view
600
45 mm
supervision devices are not damaged in this
Sponge
MILAN 76
The thickness of the sponge is 1.5mm.
The width of the sponge is 10 mm.
TOSCANA 76
The thickness of the sponge is 3 mm.
The width of the sponge is 10 mm.
GB-16
60 mm from a side or