DRIJA MILAN 76 Manual De Instrucciones página 40

installing the appliance
(A) SEALING STRIP
(C) SCREW
of the screws.There are one set of screw holes in each
corner of the hob(H).
Slightly tighten a screw(C) through the bracket(B) so
that the bracket is attached to the hob, but so that you
can still adjust the position .
2. Carefully turn the hob back over and then gently lower it
into the aperture hole that you have cut out.
3. On the underneath of the hob, adjust the brackets into a
position that is suitable for your worktop.
(B) BRACKET
Then fully tighten the screws(C) to secure the hob into
position.
MILAN 90
The width of the sponge is 10 mm.
The thickness of the sponge is 1.5 mm.
TOSCANA 90
The width of the sponge is 10 mm.
The thickness of the sponge is 5 mm.
GB-17