Far Tools GGB 4500 Traduccion Del Manual De Instrucciones Originale página 12

EN
DANGER: Never connect the generator set ear-
thing wire to piping. In addition, the piping is
carrying flammable substances such as gas or
fuel oil, there is always a risk of a fire or explosion
in the event of a short-circuit.
RECEIPT AND HANDLING :
On receipt of your generator set, check that the equipment
is in good condition and that your order is complete. The
generator should be handled with care and no sudden
movements, after preparing the area for its storage or use
in advance.
Never try to start the generator before carrying
out the preparation as described in section 2 of
the manual
EARTHING
Earth the generator set each time it is used to prevent elec-
trocution. For this purpose, use a 10 mm2 copper wire atta-
ched to the generator's earth connector and a galvanised
steel earth rod inserted 1 metre into the ground (equipment
not supplied with generator set). This earthing also dissipa-
tes the static electricity generated by electrical machinery.
118030-2-Manual-G.indd 12
ASSEMBLY AND INSTRUCTIONS FOR USE
PREPARATION FOR COMMISSIONING (BEFORE START-UP)
1. CHECKING OIL LEVEL AND TOPPING UP OIL
The oil should be checked and topped up with the generator
placed on a horizontal surface.
-Remove the dipstick cap (2) by unscrewing it.
-Inspect the level and top up if required (if it is not necessary
to top up, refasten the dipstick cap: the operation is then
complete).
-Fill with synthetic oil for gasoline 10W40 or 15W40 like
using a funnel the oil pan (<1 liter)
-Refasten the cap firmly in the filling tube.
-Wipe the excess oil with a clean cloth.
2.FILLING THE FUEL TANK
-Unfasten the cap on the fuel tank (2).
-Fill the tank with gasoline type 98 to lead without using a
funnel, taking not to spill gasoline.
-Refasten the cap onto the fuel tank
DO NOT FILL the fuel tank to overflowing level.
Leave a gap of approximately 5 mm at the top of
the tank to allow the fuel fumes to expand.
AVOID STARTING THE MOTOR OR FILLING WITH
FUEL when the spark plug cover has been remo-
ved.
Check the motor oil level before each start-up.
LOCATION FOR USE
Place the generator set on a horizontal, plane surface, which
is sufficiently resistant so that the generator does not sink.
- The angle of the generator, in each direction, must never
exceed 10° or 13%.
-Choose a clean, well-ventilated place, sheltered from adver-
se weather conditions. -Provide for oil and petrol supplies
in the vicinity of the point of use of the generator, while
observing a certain safety distance.
-Provide good ventilation if using inside a building (even in
the event of exceptional use).
-Install the generator set in an area that is not liable to obs-
truct the passage of people or animals.
EN
26/11/14 10:24:38