Know Your Product; Operation - SPARKY PMB 1632 Instrucciones De Uso

Safety Warnings Specific for Sanding
Operations:
a) Do not use excessively oversized sand-
ing disc paper. follow manufacturer's
recommendations,
sanding paper. Larger sanding paper ex-
tending beyond the sanding pad presents
a laceration hazard and may cause snag-
ging, tearing of the disc or kickback.
Safety Warnings Specific for Wire
Brushing Operations:
a) Be aware that wire bristles are thrown
by the brush even during ordinary op-
eration. Do not overstress the wires by ap-
plying excessive load to the brush. The wire
bristles can easily penetrate light clothing
and/or skin.
b) If the use of a guard is recommended for
wire brushing, do not allow any interfer-
ence of the wire wheel or brush with the
guard. Wire wheel or brush may expand in
diameter due to work load and centrifugal
forces.

Know your product

Before using the power tool, familiarize your- self with all the operating features and safety
requirements.
Use the tool and accessories only for the ap-
plications intended. All other applications are
expressly ruled out.
1. Spindle
2. Spindle lock button
3. ON/OFF switch locking button
4. ON/OFF switch
5. Closed auxiliary handle
6. Washer
7. Bolt
8b. Flexible backing pad with support flange
and fixing flange
9. Spanner SW 22
10. Pin spanner
8. Hook-and-loop flexible backing pad
11. Hook-and-loop operating tool
(abrasive sheet)
12. Operating tool with flange and nut
(wire brush)
14. Support flange
15. Fixing flange
16. Abrasive sheet
Original instructions
when selecting

Operation

These power tools are supplied from single-
phase alternating current mains only. They are
double insulated according to EN 60745-1,
IEC 60745-1 and can be connected to grounded
or not grounded sockets. This power tool is radio
suppressed in compliance with EMC Directive.
This power tool is designed for rough and fine
dry grinding, refurbishing and brushing all kinds
of surfaces.
PRIOR TO INITIAL OPERATION
▪ Make sure the power supply voltage corre-
sponds to the value indicated on the name
plate with technical data of the tool.
▪ Always check the position of ON/OFF switch.
The power tool must be connected to the
power supply socket only when this switch is
in OFF position. If the plug is connected to
a receptacle while the power switch is in the
ON position, the power tool will start operat-
ing immediately, which could cause a serious
accident.
▪ Make sure that the cord and the plug are in
order. If the replacement of the supply cord is
necessary, this has to be done by the manu-
facturer or his agent in order to avoid a safety
hazard.
WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance.
▪ In case the work area is remote from the pow-
er source, use as short as practicable exten-
sion cord with proper cross-section.
▪ Check that the auxiliary handle is properly
mounted and reliably tightened.
SWITCHING ON - SWITCHING Off
The polisher is secured against unintentional
switching on.
Brief activation:
Switching on: At first press the ON/OFF switch
locking button 3, and then press the ON/OFF
switch lever 4.
Switching off: Release ON/OFF switch 4.
Continuous operation:
Switching on: With the machine switched on
press the locking button 3 and release the ON/
OFF switch lever 4.
7
EN