Idiomas disponibles
Idiomas disponibles
safer
- Let the appliance running with no load for
30 seconds in a safe position. If you no-
ving
tice serious vibration or other defects stop
the appliance immediately. Then check the
e be-
problem and /or proceed as we describe on
Anomalies and Repair clause.
away
- The appliance can be used on surfaces such
se.
as: wood, cardboard, plastic, plaster, etc.
ories
Product description and Specifications
ories
ctive.
Description
mains
1
Keyless chuck
any
2
Torque adjustment ring.
3
Cooling vents
only,
4
Soft grip
5
Power light
use.
6
Forward/reverse switch
y the
7
On / Off / speed adjustment switch
o its
8
Battery release button
9
Battery
ould
10
Function ring
play
11
Charger
12
Gear Selector
here
C
If the model of your appliance does not
eme
have the accessories described above,
they can also be bought separately from
es or
the Technical Assistance Service.
-free
Charging the battery
Caution: A new battery is not fully charged
pera-
and must therefore be charged before the
h as
appliance is used for the first time.
oths
Caution: During the handling of batteries, do
not touch both poles at the same time, as
t dry
this will provoke the partial discharge of the
stocked energy therefore affecting longevity.
f the
- Charge the battery at an atmospheric tem-
perature of between 4 and 40ºC.
- When the battery is empty, the appliance
is switched off by means of a protective cir-
cuit. The inserted tool no longer rotates.
- Plug the charger (11) into the mains. And
the green pilot light will turn on
- Remove the battery (9) from the appliance
by pressing the battery unlocking button (8)
and pulling the battery out of the appliance
- Insert the battery (9) into the charger (11).
(Fig B)
- The green pilot light will turn off and the
red pilot will turn on to indicate that the bat-
tery is under charging process.
- Once the charge is completed the red pi-
lot light will turn off and green pilot light will
turn on.
- When the battery is charged disconnect
the charger from the mains supply.
- Remove the battery (9) pressing the bat-
tery unlocking button (8) and pulling the bat-
tery out of the appliance.
Instructions for use
Before use:
- Make sure that all the product's packaging
has been removed.
- Ensure that the voltage indicated on the
rating label matches the mains voltage be-
fore plugging in the appliance.
- Before using this product for the first time,
it is important to make a full charge of bat-
teries.
Inserting a bit:
- To open the drill's chuck (1), whilst com-
pletely switched off, take firm hold of the
back part of the chuck and turn the front
part of the chuck counter clockwise.
- Insert the drill bit, screwdriver bit, or other
tool/ accessory required for the task, into
7
