Before Fitting The Insertion Tool; Fitting The Drill Steel; Removing The Drill Steel - Atlas Copco BBC 34WS-6 Instrucciones De Seguridad Y De Funcionamiento

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 76
Safety and operating instructions

Before fitting the insertion tool

Check that the tool shank is of the correct size and
length for the chuck used. The shank must be clean
and the tool must be in good condition. Shanks which
are chipped, rounded, out of square or too hard on
the striking end will operate inefficiently and cause
premature piston failure.
Inspect the drill steel:
A dull drill steel will slow down the drilling speed and
overstrain the drill mechanism. When changing drill
steel make sure that the new one is the correct size
to follow your previous bore.
Before drilling, check that the flushing hole in the drill
steel is not blocked.
CAUTION Hot working tool
The tip of the working tool can become hot and sharp
when used. Touching it can lead to burns and cuts.
Never touch a hot or sharp working tool.
Wait until the working tool has cooled down before
carrying out maintenance work.
NOTICE Never cool a hot insertion tool in water, it
can result in brittleness and early failure.

Fitting the drill steel

Whenever fitting the drill steel the following
instructions must be observed:
16
1. Push the retainer outwards in the direction of the
arrow, until the front portion of the retainer is able
to accommodate the drill steel collar.
2. Insert the drill steel in the chuck.
3. When the drill bottoms, push back the retainer
to lock it.

Removing the drill steel

Whenever removing the drill steel the following
instructions must be observed:
© 2015 Construction Tools PC AB | No. 9800 0829 71c | 2015-10-07
BBC 34WS-6, 34WS-8
Original instructions
Tabla de contenido
loading

Este manual también es adecuado para:

Bbc 34ws-8

Tabla de contenido