Machine Operation - GYS PLASMA CUTTER 25 K Manual Del Usuario

MADE IN FRANCE
Torch consumables :
040236 (31 FV)
040229 (35 KF)
040182 (25 K)
Nozzle
2 - INSTALLATION OF THE TORCH CONSUMABLES :
Before changing the consumables, cut the power supply using the interrupor behind the machine.
To use the torch, a complete set of consumables must be installed in the correct order: electrode, diffuser, tip and nozzle.

MACHINE OPERATION

1 - PLACE THE EARTH CLAMP ON THE PART TO CUT
Ensure proper electrical contact and do not to put the cable on the cutting trajectory.
Warning: painting prevents contact between the metal part and the earth clamp, do not forget to sand.
2 - CHECK THE PRESENCE OF ALL THE CONSUMABLES ON THE TORCH AND CONNECT AS FOLLOWS :
3 - START THE MACHINE and check that the power light (1) is on.
4 - SETTINGS PANEL (FIG-2)
Green indicator (1)
When the machine is powered, the indicator is on. In case of power cut, the green indicator switches off and the machine switches off.
Yellow indicator (2)
Overheating : in this case, the yellow indicator lights up. Wait for a few minutes for the indicator to switch off and the machine will be functioning.
Overheating of the power supply : in this case the yellow indicator flashes. Unplug the machine (using the power cable) and reconnect.
Red indicator(3) (35 KF)
Error : in this case the red indicator comes up. Check the torch is connected properly and restart the machine.
5 - SETTING FOR THE AIR PRESSURE (31 FV)
In order to improve cutting performance, make sure air pressure is set to an appropriate level. To check this :
- Press the trigger of the torch (the arc starts).
- Release the trigger, the arc stops but the air continues to flow for roughly 15 seconds.
- During this period, adjust the air pressure to 5 bar using the air scroll wheel (5).
- To use on low power below 10 A, set the pressure to 3 bars.
PLASMA CUTTER 25 K / 35 KF / 31 FV
040212 (31 FV / 35 KF)
040151 (25 K) 040175
Tip Di user
Nozzle Tip
040168
Electrode
Diffuser Electrode
EN
4 m
Torch
19