Preparing Waffles - Unold Diamond Instrucciones De Uso

DE
3. Close the appliance and connect the plug to a wall socket (220–240 V~,
50 Hz). The red control lamp lights up and indicates that the heating is
EN
operational.
4. Turn the temperature control to the intermediate position to start to preheat.
FR
When the appliance has reached the preset temperature, the green control
NL
lamp lights up.
5. Heat the appliance up for a couple of minutes without dough, in order to
IT
eliminate possible manufacturing residues. Make sure the room is well ven-
tilated during this process. After the initial heating process the appliance
ES
might show signs of wear, which do not affect its features and do not con-
PL
stitute a reason for rejection.
6. Before first use, slightly grease both waffle plates with heat resistant grease
like margarine, for example, using a pastry brush (as the waffle plates are
non-stick coated, greasing is only necessary before the very first use).
7. The appliance may generate a slight smell when first using it, which is abso-
lutely normal.
8. The first waffle should not be used and should be thrown away.

PREPARING WAFFLES

1. Place the dough in the middle of the lower waffle plate using a ladle. The
dough will be spread evenly over the waffle plates by closing the lid of the
appliance. Please make sure you use the right quantity of dough. If the
quantity of dough is insufficient, the upper part of the appliance does not
close properly and the upper side of the waffles will not be as brown as the
lower side. If it is too much, the dough will overflow and soil the appliance
and the worktop.
2. Close the appliance immediately after placing the dough, so that the waffle
will brown evenly on both sides.
3. A few seconds after placing the dough, the green control lamp turns off. The
appliance will be heated up again and the baking process starts.
4. The temperature control is adjustable: with a lower level adjustment, the
waffles will be light brown and dark brown with a higher level adjustment.
Any other browning grade desired is continuously adjustable between high-
est and lowest adjustment.
Note concerning the baking signal lights: When both lights are illuminated,
5.
this means that the temperature has again been reached, however it does
22 von 80
Copyright UNOLD AG | www.unold.de
Stand 16.6.2020