Ryobi TS1144 Manual Del Operador página 15

WARNING:
This saw can tip over if the saw head is released suddenly
and the saw is not secured to a work surface. ALWAYS
secure this saw to a stable work surface before any use
to avoid serious personal injury.
MOUNTING HOLES
See Figure 8.
WARNING:
Before starting any cutting operation, clamp or bolt
your miter saw to a workbench or an approved miter
saw stand. If a miter saw stand is used, read operator's
manual and follow the instructions for the miter saw
stand. Never operate your miter saw on the floor or in a
crouched position. Failure to heed this warning can result
in serious personal injury.
The compound miter saw should be mounted to a firm sup-
porting surface such as a workbench, mounting board, or
miter saw stand. The saw base has four mounting holes. If
using bolts or screws, they should be of sufficient length to
accommodate the saw base, lock washers, hex nuts, and
the thickness of the workbench or other mounting surface.
Tighten all bolts or screws securely.
The hole pattern for mounting to a workbench is shown in
figure 8. Carefully check the workbench after mounting to
make sure that no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the workbench
to the floor before operating.
MITER LOCK KNOB
See Figure 9.
To install the miter lock knob, place the threaded stud on
the end of the miter lock knob into the threaded hole in the
control arm. Turn clockwise to tighten.
LOCKING/UNLOCKING THE SAW ARM
See Figure 9.
To unlock and raise the saw arm:
 Firmly grasp the "D" handle and apply downward pres-
sure while at the same time pulling the lock pin out and
away from the saw housing.
 Release the lock pin and slowly raise the saw arm.
To lock the saw arm:
 Firmly grasp the "D" handle and apply downward pres-
sure while at the same time pushing the lock pin in and
toward the saw housing.
 Release the lock pin allowing it to lock the saw into place.
ASSEMBLY
INSTALLING THE BEVEL LOCK KNOB
See Figure 10.
To install the bevel lock knob, slide the washer onto the
threaded stud on the end of the bevel lock knob then place
the knob into the threaded hole on the back of the saw. Turn
clockwise to tighten.
MITER
LOCK
KNOB
15 - English
CONTROL ARM
WASHER
BEVEL LOCK
KNOB
LOCK
PIN
"D"
HANDLE
Fig. 9
Fig. 10