Luminance Brands Kathy Ireland Home DORIAN ECO El Manual Del Propietario página 10

3. Ceiling Fan Assembly
3.12
Reinstall the Hanger Ball on the Downrod as follows:
Route the Five 80-inch Motor Leads through the
Hanger Ball and slide the Hanger Ball over the
Downrod (Figure 12) .
Position the Pin through the two holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
Groove in the top of the Hanger Ball (Figure 12) .
Pull the Hanger Ball up tight against the Pin and
securely tighten the Set Screw in the Hanger Ball .
NOTE: A loose set screw could create fan wobble.
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the set screw securely tightened. Failure
to verify that the pin and set screw are properly
installed could result in the fan falling.
3.13
The Fan comes with Blue, White, Grey, Red, and
Yellow Wires that are 80-inches long .
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball / Downrod
Assembly (Figure 13) .
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires .
(Continued)
PIN
HANGER BALL
DOWNROD
Figure 12
6 TO 9
INCHES
1/2
INCH
DOWNROD
Figure 13
10
SET SCREW
GREY WIRE
BLUE WIRE
WHITE WIRE
RED WIRE
YELLOW WIRE
ETL Model No.: CF515